Tree

Bring a touch of botanical elegance to your plating with our Tree stencil, designed for precise cocoa, sugar or colour dusting on plates, cakes and desserts. Cut from a single thin sheet of flexible silicone, it lies flat against any surface for crisp, clean transfers every time.

Cast in food-grade platinum-cure silicone from a precision 3D-printed master, this stencil offers fine detail reproduction of the tree pattern with smooth edges that prevent powder bleed. At just 1mm thick and 160 x 160mm, it is easy to position, hold flat and lift away cleanly without smudging your design.

A versatile tool for pastry chefs, cafés and dessert bars looking to add a signature finishing touch. Pair it with cocoa powder, icing sugar, matcha or edible glitter for seasonal menus, and reuse it indefinitely across countless plates with minimal cleanup required between uses.

Characteristics

What's in the box

• 1 × Silicone Stencil (Tree design)

Product care

• Hand wash with warm water and mild detergent before first use
• Clean immediately after use by wiping off excess powder or liquid
• Dishwasher safe on the top rack, though hand washing extends lifespan
• Dry thoroughly and store flat to avoid creases or curling
• Avoid sharp utensils that could nick or tear the thin silicone sheet
• Store away from direct sunlight and extreme heat sources

Warnings

• ⚠ For food contact use only; do not use with non-food chemicals
• ⚠ Not intended for direct oven baking contact unless specified
• ⚠ Keep away from open flame and sharp edges
• ⚠ Keep out of reach of young children to avoid choking hazard
• ⚠ Inspect before each use and discard if torn, cracked or discoloured